Remote-technologies IR-PRO T3 Manual de usuario descargar pdf (Pagina 14)

Introduction

GETTING STARTED

Start by inserting the battery connector into the mating plug on

the T3. Make sure the connector is oriented properly before

attempting to insert it. Next, turn the unit on by sliding the power

switch into the “ON” position (toward the battery).

After power is applied, the T3 will take approximately ten seconds

to load the operating system, the application software, and the

user program. This long delay only occurs from a power-down

state. During normal use the T3 turns-on instantly from its sleep

mode.

The T3 is turned-on by touching any area of the display or any

keypad button. If the tilt sensor is enabled, picking up the unit

will also turn it on.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Sin comentarios

Remote-technologies IR-PRO T3 Manual de usuario Pagina 14